Allied Telesis AT-S60 - Manual (Page 277)

AT-S60 Management Software User’s Guide
Section II: Advanced Features 277
Configuring
MSTP Bridge
Settings
This section contains the procedure for configuring a bridge’s MSTP
settings.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu is shown in Figure 91 on page 275.
2. From the Spanning Tree Menu, type 5 to select MSTP Configuration.
The MSTP Menu is shown in Figure 92.
Figure 92 MSTP Menu
Menu selections 1 to 8 are described below. Selections C, M, V, and
P are described in later sections in this chapter.
3. Adjust the MSTP settings as needed. The selections are described
below.
1 - Force Version
This selection determines whether the bridge operates with MSTP
or in an STP-compatible mode. If you select MSTP, the bridge
operates all ports in MSTP, except for those ports that receive STP
or RSTP BPDU packets. If you select Force STP Compatible, the
bridge uses its MSTP parameter settings, but sends only STP BPDU
packets from the ports.
Allied Telesyn AT-8400 Series - ATS60 V2.1.0
Engineering Switch 142
User: Manager 00:14:33 15-Jan-2004
MSTP Menu
1 - Force Version .......... MSTP
2 - Hello Time ............. 2
3 - Forwarding Delay ....... 15
4 - Max Age ................ 20
5 - Max Hops ............... 20
6 - Configuration Name .....
7 - Revision Level ......... 0
8 - Bridge Identifier ...... 00:30:24:1E:EE:11
C - CIST Menu
M - MSTI Menu
V - VLAN-MSTI Association Menu
P - MSTP Port Parameters
R - Return to Previous Menu
Enter your selection?