Allied Telesis AT-S60 - Manual (Page 115)

AT-S60 Command Line User’s Guide
113
ADD SWITCH MIRROR
Syntax
add switch mirror=destinationport port=sourceport
Parameters
mirror Specifies the destination port of the port mirror where
you want to add more source ports. This port must
already be functioning as a destination port of a port
mirror. (For information on how to specify ports, refer
to Specifying Ports on page 17.)
port Specifies the new source port of the port mirror. You
can specify more than one port at a time, but there
can be only one source port per line card.
Description
This command adds new source ports to an existing port mirror. Any
source ports already assigned to the port mirror are retained and are not
overwritten by the new source ports.
To create a port mirror, refer to CREATE SWITCH MIRROR on page 114.
To view the ports of a port mirror, refer to SHOW SWITCH MIRROR on
page 120.
Example
The following command adds Port 3 on the line card in Slot 11 as an
additional source port to the existing port mirror that is using Port 1 on
the line card in Slot 2 as the destination port:
add switch mirror=2.1 port=11.3