Allied Telesis AT-8116 User Manual
At-8116 fast ethernet intelligent switch
Advertising
Table of contents
Document Outline
- user’s GUIDE
- Table of Contents
- Chapter1
- Chapter2
- Chapter3
- Chapter4
- System Commands
- sys-stat
- i/f 1 -- description [Port 1 - 10/100BaseTx ETHERN...
- i/f 2 -- description [Port 2 - 10/100BaseTx ETHERN...
- i/f 3 -- description [Port 3 - 10/100BaseTx ETHERN...
- i/f 4 -- description [Port 4 - 10/100BaseTx ETHERN...
- i/f 5 -- description [Port 5 - 10/100BaseTx ETHERN...
- i/f 6 -- description [Port 6 - 10/100BaseTx ETHERN...
- i/f 7 -- description [Port 7 - 10/100BaseTx ETHERN...
- i/f 8 -- description [Port 8 - 10/100BaseTx ETHERN...
- i/f 9 -- description [Port 9 - 10/100BaseTx ETHERN...
- i/f 10 -- description [Port 10 - 10/100BaseTx ETHE...
- i/f 11 -- description [Port 11 - 10/100BaseTx ETHE...
- i/f 12 -- description [Port 12 - 10/100BaseTx ETHE...
- i/f 14 -- description [Port 14 - 10/100BaseTx ETHE...
- i/f 15 -- description [Port 15 - 10/100BaseTx ETHE...
- i/f 16 -- description [Port 16 - 10/100BaseTx ETHE...
- Software resets number implies executed “warm rese...
- System Commands
- Chapter5
- Chapter6
- Chapter7
- Chapter8
- Chapter9
- Chapter10
- Chapter11
- Chapter12
- Chapter13
- Chapter14
- Chapter15
- Chapter16
- AppendixA
- Software Downloading
- Requirements
- 8116 TFTP Client Download Procedure
- 1. Insure that an IP Address is assigned.
- 2. Set the TFTP mode to client using the set-tftp-...
- 3. Insure that the host system for the TFTP server...
- 4. Insert the diskette with the software file into...
- 5. Select/Create a directory into which to copy th...
- 6. Copy the software file into a file with a suita...
- 7. Set the remote software file using the set-sw-f...
- 8. Operate TFTP server on the remote system host a...
- 8118 TFTP Server Download Procedure
- 1. Insure that an IP Address is assigned.
- 2. Set the TFTP mode to the server using the set-t...
- 3. Set the remote software file using the set-sw-f...
- 4. Insure that the host system for the TFTP client...
- 5. Insert the diskette with the software file into...
- 6. Select/Create a directory into which to copy th...
- 7. Copy the software file into a file with a suita...
- 8. Set the remote software file using the set-sw-f...
- 9. Use the sw-dnld command to start download.
- 10. Operate the remote TFTP client.
- 11. Select binary transfer mode if the code is in ...
- 12. Using the TFTP protocol, send the file (to be ...
- Software Downloading
- AppendixB
- AppendixC