Allied Telesis AT-8116 - Manual (Page 25)

AT-8116 User’s Guide
4-5
sw-dnld
This command begins the software download process from the
remote TFTP server specified by the set-tftp-srvr command,
retrieving the file specified by the set-sw-file command.
set-fg-param
set-fg-param sets the Ethernet frame generator parameters
[arg #0] destination address in hex format xx-xx-xx-xx-xx-xx
[arg #1] source address in hex format xx-xx-xx-xx-xx-xx
[arg #2] frame fill pattern - hex byte
[arg #3] frame length - including DA, SA and type/length
This command sets the frame generator parameters. dest and source
are dash-separated hardware addresses in hex. fill_byte is a single
byte used to fill the entire packet except for the first 12 bytes. length
is the total length of the packet excluding CRC.
SYS_console>set-fg-param 00-0E-DE-02-80-01
00-0D-01-32-11-22 aa 100
SYS_telnet>
SYS_telnet>start-fg?
?
start-fg
start-fg starts the Ethernet frame generator
[arg #0] destination ports - ports list in decimal format: d-d-d-..-d
[arg #1] number of frames to be generated - 0=forever
[arg #2] frame per second
SYS_telnet>