Allied Telesis AT-8202 User Manual
At-8202 atm uplink
Advertising
Table of contents
Document Outline
- user’s GUIDE
- Preface
- Features
- Configuring the ATM Port
- Configuring Classical IP Over ATM (CIP)
- When using CIP, make sure that the ATM port is con...
- 1. Create a VLAN with a valid IP address, using th...
- 2. Create a CIP service.
- 3. Set the connection type.
- 4. Set the following values:
- 5. Define an IP address and subnet mask for this C...
- 6. Save the CIP configuration
- To configure CIP services:
- Figure1-2 Configuring CIP
- Table1-2 CIP Configuration Parameters
- 3. Enter 2 at the prompt to enable the IP address ...
- 4. Enter the IP address.
- 5. Enter the subnet mask.
- 6. Enter the connection type (PVC or SVC).
- 7. Define the VCI value if your Step6 entry is PV...
- 8. Keep the default value for MTU size.
- 9. Set the RIP mode.
- 10. Enter 0 to save the configuration.
- Table1-2 CIP Configuration Parameters
- To connect two switches for CIP service, you must ...
- When using CIP, make sure that the ATM port is con...
- Configuring the LAN Emulation Client (LEC)
- Configuring Point-to-Point (PTOP)
- Configuring Trunking
- Where to Go Next
- Chapter2
- ATM Commands
- How Commands are Organized
- Entering Commands
- Command Edit Mode
- ATM Command Descriptions
- ATM/CONFIG/CREATE Commands
- ATM/CONFIG/DELETE Commands
- ATM/CONFIG/DISABLE and ENABLE Commands
- ATM/CONFIG/MODIFY Commands
- ATM/SHOW Commands
- CIP 5 ARP Table Display
- Table2-7 ATM/SHOW/ARP/CIP Parameters
- Table2-8 ATM/SHOW/ARP/LEC Parameters
- Table2-9 ATM/SHOW/CIP Parameters
- Table2-10 ATM/SHOW/CIP <CIP Index> Parameters
- Table2-11 ATM/SHOW/CONNECTION Parameters
- Table2-12 ATM/SHOW/CONNECTION <VCI> Parameters...
- Table2-13 ATM/SHOW/LEC <LEC Number> Parameters ...
- Table2-14 ATM/SHOW/PORT Parameters
- Table2-15 ATM/SHOW/PTOP Parameters
- Table2-16 ATM/SHOW/TRUNK Parameters
- ATM/STATS Commands
- Table2-17 ATM/STATS/AALS Parameters
- Table2-18 ATM/STATS/ATM Parameters
- Table2-19 ATM/STATS/CIP <CIP Index> Parameters...
- Table2-20 ATM/STATS/CONNECTION Parameters
- Table2-21 ATM/STATS/LEC <LEC Number> Parameters...
- Table2-22 ATM/STATS/PTOP <PTOP Number> Paramete...
- Table2-23 ATM/STATS/SIG Parameters
- Table2-24 ATM/STATS/TRUNK <Trunk Number> Parame...
- ATM/TEST Command
- AppendixA
- Index