Enter 5 at the prompt for vci value configurati, You must enter a vci value when configuring a pvc, Enter the vci value when prompted – Allied Telesis AT-8202 User Manual
Page 26: Enter 0 to save the selection, Bind the port service for trunking by using the, Use the value of 34 for binding port service to tr
Configuring Trunking
1-18
3. Enter
5
at the prompt for VCI value configuration.
Note
You must enter a VCI value when configuring a PVC connection type.
Additionally, make sure the PVC number is identical on all
FORMULA 8200 switches. This must be a different value from the
PTOP.
4. Enter the VCI value when prompted:
5. Enter
0
to save the selection.
6. Bind the port service for trunking by using the
/PORTSERV/
CONFIG/CREATE
command.
Note
Use the value of 34 for binding port service to trunk for ATM.
Enter Selection, 0 to save the Modification or 'q' to Quit:
5
Enter VCI value: 502
TRUNK Configuration
1. TRUNK Index:
1
2. Description (Optional):
TRUNK Instance 1
3. Admin Status(ENABLE(a),DISABLE(b):
ENABLED
4. Connection Type (PVC(a), (SVC(b):
PVC
5. VCI value (Reqd if PVC):
502
6. Destination ATM Address (reqd if SVC):
Enter Selection, 0 to save the Modification or ‘q’ to Quit: 0
New VCI value
Enter Selection, 0 to save the Modification or 'q' to Quit:
0
Updating ATM configuration...