Atm/config/modify commands, Atm/config/modify commands -19 – Allied Telesis AT-8202 User Manual
Page 47
AT-8202 ATM Uplink User’s Guide
2-19
ATM/CONFIG/MODIFY Commands
Syntax and (alias)
ATM/CONFIG/MODIFY/CIP (mcip)
ATM/CONFIG/MODIFY/LEC (mlec)
ATM/CONFIG/MODIFY/PORT (map)
ATM/CONFIG/MODIFY/PTOP (mptop)
ATM/CONFIG/MODIFY/TRUNK (mtrunk)
Description
The
ATM/CONFIG/MODIFY
commands allow you to modify services
that you have created (via the
ATM/CONFIG/CREATE
command).
See the command examples for a brief description of these services.
ATM/CONFIG/MODIFY/CIP <CIP Index> Example
This command allows you to modify a CIP entity (a member of an LIS)
using <CIP Index>. If that index does not exist, the screen displays
the error message,
No Such CIP
. This command displays the same
screen as the
ATM/CONFIG/CREATE/CIP <CIP Index>
command.
You can modify some of the parameters of the CIP entity while the
CIP is in service, and without affecting the open connections
associated with that CIP. However, you cannot modify certain
parameters such as the IP address, subnet mask, etc. without taking
the CIP entity out of service. Under these conditions, use
ATM/
DELETE/CIP
followed by
ATM/CREATE/CIP
in place of
ATM/
MODIFY/CIP
.
ATM/CONFIG/MODIFY/LEC <LEC Number> Example
This command allows you to modify a LEC as specified by <LEC
Number>. If that index does not already exist, the screen displays the
error message,
LEC <LEC Number> does not exist
. This
command displays the same screen as
ATM/CONFIG/CREATE/LEC
<LEC Number>
.
ATM/CONFIG/MODIFY/PORT Example
The ATM port is configured with certain default parameters. This
command changes some of the default settings to suit a specific
network configuration. A sample display of
ATM/CONFIG/MODIFY/
PORT
is shown below, and parameters are described in Table 2-6.