Allied Telesis AT-8324 User Manual
Page 51
Advertising
AT-8316F and AT-8324 Installation Guide
51
7. Set the Stack ID switch on the master switch to 1. Refer to Figure
3-7 for the location of the Stack ID switch.
8. Set the Stack ID switch on one slave switch to 2 and set the Stack
ID switch on the other slave switch to 3.
Note
Do not use a setting of 0 (zero) or 9. These settings are invalid.
9. Connect the data cables to the ports on the front of each switch.
10. Go to the procedure Powering On a Stack on page 3-57.
Advertising
This manual is related to the following products: