Show ip – Allied Telesis AT-S47 User Manual
Page 96
Advertising
Section III: Command Line Interface
96
SHOW IP
Syntax
show ip
Parameters
None.
Description
This command displays the current values for the following multiplexer
parameters:
❑ IP address
❑ Subnet mask
❑ Default gateway
Note
To set these parameters, refer to the SET IP command on page 94.
This command also displays the IP addresses of management
workstations to receive traps from the multiplexer.
Example
The following command displays the IP address, subnet mask, and
gateway address of the multiplexer:
show ip
Advertising