Swiftech APEX ULTRA PLUS User Manual
Page 22
Copyright Swiftech 2006 – All rights reserved – Last revision date: 08-30-06 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US): 866-857-9438 – Fax 562-595-8769 - E Mail:
PAGE 22 of 36
Installation with Intel compatible motherboards
You can either leave the AMD brackets providing that they do not interfere with components on your motherboard, or you can remove
them. If you do remove the brackets, please use the provided 4-40 x 5/16” socket screws to reassemble the water-block.
Removal of the motherboard is NOT necessary to install the MCW30 in this configuration.
•
Remove the existing heatsink
•
Clean off the CPU with a degreaser, and spread some of the included thermal compound over it.
•
Install the MCW30 over the CPU
•
Insert the hooks of the wire clips 7 underneath the loops of the motherboard.
•
Installation is now complete
4. R
E
-
INSTALLING THE MOTHERBOARD
Now that the APOGEE and MCW30 water-blocks are securely fastened to the motherboard, go-ahead and install the motherboard into
the chassis, following the instructions provided in your motherboard installation guide.