Swiftech APEX ULTRA PLUS User Manual
Page 23
Copyright Swiftech 2006 – All rights reserved – Last revision date: 08-30-06 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 3700 Industry Avenue, Suite 104, Lakewood, CA 90712 – Toll free (US): 866-857-9438 – Fax 562-595-8769 - E Mail:
PAGE 23 of 36
5. MCW60
VGA
WATER-BLOCK
INSTALLATION
Overview
The MCW60 is shipped with a pre-assembled hold-down plate compatible with all nVidia High-end GeForce and ATI Radeon using a
four-hole fastening system. Mid-range ATI products using a 2-hole bolt-down are also compatible by using the included haldware. Please
refer to our product page for further information.
4-holes setup
2-holes setup
1/ ATI 2-hole bolt-down ONLY: pre-installation steps
You will need to remove the chrome hold-down plate as shown below, before you can install the product with ATI 2-hole boards. Once
done, please follow the steps common to all VGA adapters, and the installation schematic provided page 2.
Remove all four screws with the provided Hex key and set aside
the chrome hold-down plate, as it will not be needed.
Re-install the four screws, using the provided lock-washers. Your
water-block is now ready to use with ATI 2-hole bolt pattern.
Common installation steps to all graphics cards: General information
•
The MCW60 VGA water-block may be installed in any direction.
•
The inlet and outlet are interchangeable with respect to flow direction.
BEFORE INSTALLATION
•
Install the barb fittings with their o-rings into the water block before you fasten the water-block to the VGA card
•
Tighten each fitting until the flange of the fitting mates with the ledge of the water-block o-ring groove, then lock it by
adding ¼ to ½ turn.
•
Remove the existing heat sink from your graphics card, and carefully clean off the GPU with an electronics degreaser.