Swiftech H20 120 T - Manual (Page 10)

Packing list
MCR120 radiator 1 ½” barbs 2
Snap-rivet 4 120x25mm fan 1
6-32” x 3/8” Philips screw 4 #6 worm drive clamps 2
Front
of
Chassis
Snap-rivet
6-32 x 3/8" philips
MCR120 radiator
120mm fan
Figure 2 – Front of chassis installation
Preamble
The MCR120-F
 ships with the fan pre-assembled to the radiator. It has been configured so that the fan will draw fresh air from outside of the
chassis. This configuration is preferred to optimize cooling of the CPU. In effect, if the fan flow direction were reversed, it would use heated air inside
of the chassis, which is usually 3
°C (at best) and up to 10°C hotter than that of the ambient air outside of the chassis.
1. Installation
In this kit, the preferred installation location of the MCR120-F  is at the front of the chassis. Due to the wide variety of chassis configurations,
Swiftech cannot guarantee that this assembly will bolt into any chassis without some modifications.
2. Bleeding
For bleeding purposes, the preferred radiator orientation is with inlet and outlet pointing up as shown above. Nonetheless, the radiator can also be
installed at 90
° or 180°. In such cases, simply rotate the radiator back upwards to allow the air trapped inside to escape during the filling and bleeding
process. For this reason, it might be more convenient to fasten the radiator to the chassis after the circuit has been fully filled and bled.
Specifications
Radiator Assembly Dimensions - Part # MCR120-FB
Thickness Height Core width Inlet Outlet tube size
0.98"
(25mm)
5.9"
(157mm)
5.00"
(133mm)
1/2" (tube OD) quick connect adapters included
Fan Specifications - Part # WFB1212M
Voltage
(V)
Current
(mA)
Speed
(RPM) Volume
(CFM)
Static pressure
(InH20)
Sound Noise
(dbA)
7.0-13.8 .20 2100 72.4 .134 34
Rouchon Industries, Inc., dbA Swiftech™ – 1703 E. 28 th St, signal Hill, CA 90755, USA – T (562) 595-12009 – F (562) 595-8769 – All content
Copyright Swiftech 2004 – Last edited 9-11-04 – Subject to revision without notice - 10 of 37 -