Pentium, 4 (socket 478), Preparing the motherboard – Swiftech H20 220 T User Manual
Page 10
2. MCW5002-PT™ THERMOELECTRIC WATER-BLOCK INSTALLATION GUIDE FOR INTEL
® PENTIUM® 4
(SOCKET 478)
Figure 1
A. Preparing the Motherboard
Copyright Swiftech 2005 – All rights reserved – Last revision date: 12-27-05 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 10 of 32
Remove the stock heatsink retention frame (the black plastic
frame that clips down to your motherboard). This will reveal
the four mounting holes used to install the MCW5000-PT
™
retention standoffs.
Install a standoff in each one of the holes. As the diameter of
the mounting holes is much larger than the diameter of the
standoff stem, be careful to keep the standoff approximately
centered in the MB holes. Secure standoffs with hex locknuts,
and a fiber washer on backside of the MB as shown on fig. 1,
using the tools described fig. 2
Figure 2