Swiftech H20 220 T - Manual (Page 25)

Remove the radiator assembly from the back-plate and mark the
center of the circle.
Two rubber grommets are provided with your kit so that you can
route the tube though the case without damaging the tubing with
the sharp edges of the hole. The required hole diameter for the
grommet is 7/8” (23mm).
To cut the holes, use a heavy-duty Bimetal hole saw of 7/8” in
diameter:
Once the two holes are cut, de-burr the edges, and install the
grommets.
Install your radiator assembly onto the back plate.
Once the tubes are connected to the radiator,
the final results will look like so:
Finally, you need to route the fan wires through the back-
panel. This can be done easily with the provided PCI adapter
plate featuring a hole and grommet for protection of the wire.
Copyright Swiftech 2005 – All rights reserved – Last revision date: 12-27-05 - Information subject to change without notice – URL: http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28 th Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 25 of 32