Components (other than water-block) installation, S320-12 power supply kit installation guide, S320-12 power supply installation – Swiftech H20 220 T User Manual
Page 19
Type of Coolant:
For best performance, use 5 to 10% of Swiftech brand “HydrX” corrosion inhibitor mixed with distilled
water only .
Regular automotive anti-freeze is also acceptable. Automotive manufacturers recommend that not less than
25% is used.
NEVER use tap water, even for a short-term test.
Not following the above instructions constitutes misuse (*) of the product, and will void your warranty.
wires.
Now that the water-block installation is complete, please proceed with the rest of the components installation as described in Chapter
2.
II.
COMPONENTS (OTHER THAN WATER-BLOCK) INSTALLATION
Set aside your motherboard/water-block assembly in a safe place, and start working on your chassis. There is no critical order in the
suggestions below, other than good common sense. Choices will depend on the layout of your own chassis.
1. S320-12 POWER SUPPLY KIT INSTALLATION GUIDE
Qty Item
1
S320-12 power supply installed in 5 ¼” adapter tray, screws
1 Electrical
harness
1 Relay
Switch
1
A/C socket adapter, stainless steel cover plate, screws
1 A/C
cord
1
80mm fan guard with (4) snap rivets
Preamble
This kit has been designed to facilitate installation with as little modifications to the case as possible. It is however meant for advanced
users, well versed in installing computer components.
Specific tools needed to complete the
installation:
Power drill
1 ¼” (32mm) Bi-Metal hole saw to drill hole
for A/C socket
1/8” (3.17mm) Drill bit for A/C socket cover
mounting holes
Optionally: 3 ¼” Bi-Metal hole saw to drill an
80mm blow hole above the power supply fan
exhaust
General Rules:
Always work on a “naked” case, removing side panels, front bezel, and top panel, with no power supply installed.
Never work with electricity connected to the computer while work is in progress.
Strip the case “naked”: Since you will be making holes in the case, metal debris could be flying off into your components, and a
“naked” chassis will be easier to clean-up.
A. S320-12 Power supply installation
Copyright Swiftech 2005 – All rights reserved – Last revision date: 12-27-05 - Information subject to change without notice – URL:
http://www.swiftnets.com
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E Mail: [email protected]
PAGE 19 of 32
Install the power supply in a 5 ¼” bay, preferably in the uppermost slot as shown in figure 1. Use the provided screws to secure tray to
the chassis.