Nilfisk-ALTO DIGITAL X OVER - Manual (Page 6)

3.2.The Rear Panel
Inputs(14)
These are XLR balanced connectors which connect to sources such as the channel inserts on mixing
consoles. They may be used with nominal input levels f om consumer to professional audio.
r
Outputs(15)
LTODRIVE3.4 has 6 outputs, they are XLR balanced connectors which connect to devices such as
the channel inserts on mixing console or power amplifier inputs .
MIDI Connectors(16)
-MIDI in: 5-poles DIN connector for the MIDI input to the LTODRIVE3.4.
-MIDI thr: 5-poles DIN connector for the MIDI thr.
-MIDI out: 5-poles DIN connector for the MIDI output f om the
LTODRIVE3.4. r
Power Connector(17)
This is an IEC 3-pole socket for connecting the AC power supply to the LTODRIVE3.4.
4. INSTALLATION & CONNECTION
5
Power SW with LED (1)
Turns the apparatus on and off. Press this SW, the power LED inside the SW will turn on.
Dial Control knob (5)
Used to change editable values.
14.Input Connector for Input1 and Input2
15.Output Connector for Output1~Output6
16.MIDI Connector
17.Power Connector
4.1.Power Up and Audio Connections
a. Audio Connections
b. Power Up Setting
The connections between the LTODRIVE3.4 and the other audio devices have to be made using high
quality cables so to prevent bad performances of the LTODRIVE3.4 itself. So it should be good to use
low-capacitance shielded cables with a flexible internal conductor. Connect the cables to the LTODRIVE3.4
properly by observing the following precautions:
Do not bundle audio cables with AC power cords.
Do not place audio cables and
LTODRIVE3.4 near sources of electromagnetic interference such as
transformers, monitors, computers, etc.
Always unplug cables by firmly grasping the body of the plug and pulling directly outward.
Do not place cables where they can be stepped on.
Avoid twisting a cable or having it make sharp, right angle turns.
Before turning on the LTODRIVE3.4's power, check if:
All connections have been made correctly.
The volume controls of the amplifier or mixer are turned down.
INPUT1 INPUT2 OUTPUT1 OUTPUT2 OUTPUT3 OUTPUT4 OUTPUT5 OUTPUT6 INPUT THRU OUTPUT
MIDI AC INPUT
95-240V 60-50Hz
Rated Power Consumption 15W
FUSE:
210-240V: T250mAL 250VAC
95-120V: 500mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk SERIAL
MODEL
PUSH
2 1 3
NEW TIDE
PUSH
2 1 3
NEW TIDE
14 15 16 17
Insert the Power plug into the POWER input on the rear panel of the LTODRIVE3.4 and plug the power cable
into an AC outlet.
Turn on the power of the
LTODRIVE3.4, pushing the ON/OFF button on the front panel.
Turn on the power of the amplifier/mixer, and adjust the volume.