AMCC 3WARE 9690SA - Manual (Page 23)

Installing the Control Module
www.3ware.com 19
To install the control module
Note: The following illustrations show the 9690SA-4I4E. If you
have a 9690SA-8E the location of the control module post hole will
be different.
1 Remove the screw head from the plastic post on the BBU
control module and set it aside (you will reattach it soon.)
Figure 11. Removing the head from the plastic post
2 Position the BBU control module above the controller
(Figure 12) and align the BBU control module and the
controller, making sure to:
„ Mate the connector on the BBU control module with the
receptacle on the controller.
„ Match the plastic post on the BBU with the hole on the
controller.
Figure 12. BBU control module ready to connect to the
controller