Remove the contact protector, Charge the battery – Nikon D4S User Manual

Page 44

Advertising
background image

22

s

3

Remove the contact protector.

Remove the contact protector from the
charger battery chamber.

4

Charge the battery.

Insert the battery (terminals first), aligning the end of the
battery with the guide and then sliding the battery in the
direction indicated until it clicks into place. The chamber lamp
and charge lamps will flash slowly while the battery charges:

Charging is complete when the chamber lamp stops flashing
and the charge lamps turn off. About 2 hours and 35 minutes
are required to fully charge an exhausted battery; note that
the battery will not charge if its temperature is below 0 °C
(32 °F) or above 60 °C (140 °F).

Charge state

Chamber

lamp

Charge lamps

50%

80%

100%

Less than 50% of maximum capacity

H (flashes

slowly)

H (flashes

slowly)

I (off)

I (off)

50–80% of maximum capacity

H (flashes

slowly)

K (glows)

H (flashes

slowly)

I (off)

More than 80% but less than 100% of
maximum capacity

H (flashes

slowly)

K (glows) K (glows)

H (flashes

slowly)

100% of maximum capacity

K (glows)

I (off)

I (off)

I (off)

Guide

Chamber

lamps

Charge
lamps
(green)

Contacts

Advertising