Nikon S710 - Manual (Page 156)

144
Troubleshooting
Techni
cal N
o
te
s
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Monitor turns off, and the
power-on lamp and flash lamp
blink rapidly Battery temperature is high. Turn off camera,
and allow battery to cool down before resuming
use. After 5 seconds, this message will disappear,
the monitor will turn off, and the power-on lamp
and flash lamp will blink rapidly. After the lamps
blink for 3 minutes, the camera will turn off
automatically, but you can also press the power
switch to turn it off manually. 15
Problem Cause/Solution A