Installation firebox liner panels – Aarrow Fires EcoBurn BK043 User Manual

Page 16

Advertising
background image

16

Aarrow Ecoburn Wood & Multifuel Stoves

INSTALLATION

FIREBOX LINER PANELS

The Aarrow Ecoburn Wood and Multifuel stoves
use firebox liner panels to the sides and back of the
firebox. The throat plate sits on top of the side and
rear panels. These should come fitted to your stove,
if however they are not proceed as follows to fit
them as follows -

•Open the fire door.

•Remove the two round front fuel retaining bars, by
lifting one end free of the bracket and sliding the
remaining end out from the bracket.

•Set the small liner(s) into the back of the fire.

•Insert side liner panels. (See Fig. 10).

•Fit the throat plate with the single bend and two
cut outs to the front facing up. The projecting lugs
sit on top of the side liners. The long centre tab on
the back edge rests on the rear liners.The shorter
turn-down tabs against the vertical face.(See Fig.
11 & 12 ).

•Replace the front fuel retainer bars.

Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire.

Note: Cracking of lining panels does not effect
efficiency.

Fig. 9. Overall View Of Liners & Throat

Plate.

Fig. 10. Liners inserted

Fig. 11. Inserting the throat plate

Fig. 12. Liners & throat plate

correctly fitted

Advertising
This manual is related to the following products: