Avalon Acoustics Sentinel - Manual (Page 21)

21
3.3 Crossover Cabinet Set-up
CAUTION: Three people are required for the set-up procedure. To avoid injury,
do NOT attempt to set-up by oneself.
1. Lay the crossover cabinet on one side, just behind the speaker cabinet,
using a blanket or other soft material to avoid scratching the finish. The
cabinet should be oriented so that output terminals are adjacent to the back
surface of the speaker cabinets (see Figure 3.6).
2. Install four Apex‘ couplers on the bottom of the cabinet by fastening the
threaded ends of the couplers into the cabinet inserts (see Figure 3.2). Lightly
tighten the couplers and insure that the base of the coupler contacts the
bottom of the recess.
3. Do NOT stand up the crossover cabinet at this time, as you will need to
connect upper speaker harnesses to the output terminals in Section 4.
Figure 3.6 – Proper placement of crossover cabinet behind speaker.
INPUTS
OUTPUTS