Audiovox FPE709 User Manual
Page 12
12
Connecting a TV Antenna/ Cable to Receive Channels
To view television channels correctly, a signal must be received
from one of the following sources:
1. An indoor or outdoor antenna
2. A cable system, note that after your subscription is active, unplug
the Antenna from the TV as shown below. Then plug in the cable
from the cable company to the RF IN on your TV.
Using antenna/cable to receive programs
a. For the first time you turn on the TV, there is not any channel
stored, a pop-up screen appears:
“Do you want to proceed with
auto scan?
” The selection of YES enables you to perform a auto
scan without navigating to the channel setup menu first.
b. After finishing auto scan, a channel list will be save in the TV.
You can also follow below steps to re-scan the available
channels for your TV.
1. Press the SOURCE button to make sure your TV is in the TV
mode.
2. Press the MENU button to enter the main menu.
3. Press the RIGHT button twice to highlight the
“Antenna icon”.
4. Press the DOWN ARROW (CH-) to highlight the Antenna
selection.
PDF created with FinePrint pdfFactory Pro trial version
http://www.fineprint.com
Unplug Antenna
Connect Cable
from your Cable
Company