ATEN CE-250 - Manual (Page 9)

Installation
Setting up the KVM Extender System is simply a matter of plugging in
the cables:
1. Make sure that all the equipment to be connected up is powered Off.
2. Plug the cables from the local console devices (mouse, keyboard,
monitor), into their ports on the Console side of the Local Unit
(CE-250L).
3. Plug the appropriate connectors on the KVM cable supplied with this
unit into the CPU side of the CE-250L. Each connector is marked
with an appropriate icon to indicate which it is.
Note: The female monitor connector is the one that plugs into the
CE-250L.
4. Plug the connectors on the other end of the cable into the
appropriate ports on the computer system (or Console section of the
KVM switch - if you are using one). Each connector is marked with
an appropriate icon to indicate which it is.
5. Plug either end of the Category 5 twisted pair cable into the
CE-250L’s Remote I/O port.
6. Plug one of the power adapters (supplied with this package) into an
AC source; plug the adapter’s power cable into the CE-250L’s
Power Jack
7. Plug the other end of the Category 5 twisted pair cable into the I/O
port of the Remote Unit (CE-250R).
8. Plug the cables from the remote console devices (mouse, keyboard,
monitor), into their ports on the Console side of the CE-250R.
9. Plug the second power adapter (supplied with this package) into an
AC source; plug the adapter’s power cable into the CE-250R’s
Power Jack.
- 7 -
2002-12-16