ROTHENBERGER ROMAX 3000 - Manual (Page 20)

ENGLISH 14
RISK OF EXPLOSION!
Physical injury!
The battery charger may not be used to charge other batteries or rechargeable batteries.
Ventilation slots of the battery charger must not be covered up.
Please pay attention to the following symbol on the label of the charger:
This tool is only suitable for indoor use. Never expose tool to rain!
No metal parts must be allowed to enter the battery section of the charger (short circuit risk).
RISK OF FIRE! Short-circuit! Do not bridge contacts of the battery charger
with metal parts!
Do not charge battery in direct sunlight. Only use the battery in an ambient temperature
between -10°C and 60°C.
RISK OF FIRE! Never charge batteries near acids and highly flammable materials.
Battery fluid may leak from damaged removable batteries under conditions of extreme load
or extreme temperatures. Any areas that have come into contact with battery fluid should be
washed immediately with soap and water. If battery fluid comes into contact with the eyes rinse
them thoroughly for at least 10 minutes and consult a doctor immediately.
Do not store batteries with metal objects (danger of short circuit).
Check before each use: Carry out a visual inspection each time before using the battery charger.
Never charge a damaged battery pack. Replace by a new one.
The mains power cable / charging cable must be inspected regularly for signs of damage and
ageing (brittleness) and may only be used in perfect condition.
Never break open battery packs and chargers and store only in dry rooms. Keep dry at all times.
End of charging / storage:
So that the fully charged battery is not discharged, the battery should be disconnected from the
battery charger.
Store the battery charger with disconnected mains plug.
Storage temperature 0° - 30°C.
2 Technical data ROMAX 3000
Battery voltage ..................................................................... 18V
Battery capacity ..................................................................... 3,0 Ah
Rated power consumption .................................................... 540 W
Motor speed ......................................................................... 22000 1/min
Maximum piston force .......................................................... 32 kN
Pressing time (according to nominal size) .............................. ca. 5 s
Dimensions (L x W x H) ......................................................... 445 x 125 x 79 mm
Weight (without battery) ....................................................... ca. 2,9 kg
Working range ...................................................................... ø 12 - 108 mm (system- dependent)
Application temperature range ............................................. -10°C - 60°C / 14°F – 140°F
Operating mode ................................................................... S3
Typical acceleration in hand-arm area ....................................
≤ 2,5 m/s2
Sound pressure level (L
pA
) ..................................................... 71 dB (A) ¦ K
pA
3 dB (A)
Sound power level (L
wA
) ....................................................... 82 dB (A) ¦ K
wA
3 dB (A)
The noise level during operation can exceed 85 dB (A). Wear ear protection!
Measurements found in compliance with EN 60745-1.