ROTHENBERGER ROMAX 3000 - Manual (Page 23)

ENGLISH 17
4 Care and Maintenance
ROMAX 3000:
Remove the battery prior to carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must be
sent to an authorised Rothenberger repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an
authorised ROTHENBERGER repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorised
ROTHENBERGER repair shop.
If the seal is damaged the warranty will be null and void.
After 20.000 pressing cycles or 2 yeas have the machine serviced by an authorised
ROTHENBERGER workshop.
When dispatching the machine ensure that it is packed in its carrying case completely with battery
and charger in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C storage.
Disconnect battery from machine before storing.
Charger:
If the supply cord of this appliance is damaged, it must only be replaced by a repair shop
appointed by the manufacturer, because special purpose tools are required.
5 Accessories
The relevant accessories can be found from page 160 onwards.
6 Disposal
Components of the unit are recyclable material and should be put to recycling. For this purpose
registered and certified recycling companies are available. For an environmentalfriendly disposal of
the non-recyclable parts (e.g. electronic waste) please contact your local waste disposal authority.
Old batteries can be taken to your specialist dealer who will dispose of them in conformity with
environmental regulations.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European Direc-
tive 2012/19/EC on waste electrical and electronic equipment and its implementation as
national law, electric tools that are no longer serviceable must be collected separately and
utilised for environmentally compatible recycling.