Ferguson Ariva Link 200 - Manual (Page 18)

FIRST STEPS
1. Insert the plug of the receiver and other additional devices to a wall socket.
2. Select AV signal source of your television set.
3. The satellite receiver is supplied with reinstalled television channels. In order to watch other,
i.e. non-default channels, you should use channel search function.
Note: check all of the connections, i.e. antenna cables, audio and video signal cables,
before connecting the receiver to the mains!
INFORMATION ABOUT THE USER MENU
The user interface allows you to use numerous settings and receiver functions. Some buttons on
the remote control unit enable direct access to functions of the device. Certain of these buttons
have been described, for example EPG, MENU, OK, or coloured for ease of usage. Other
buttons are multi-functional and their operation depends on the type of device selected by the
user. Hereunder we have presented a brief description of how to use certain device functions
available through the user menu.
1. The up/down arrow keys on the remote control are used to move the cursor up and down on
the menu.
2. The left/right arrow keys on the remote control are used to move the cursor left and right,
and to switch on submenus
3. The OK button is used to enter submenus.
4. The EXIT button is used to exit menus or functions.
5. When using a submenu, the OK button is used to confirm your selection; a green background
informs that a function is active.
Powering On/Off
Power ON/Booting
Connect the power cord of your device to a mains socket. Turn On the mains switch on the
rear panel to start the booting.
Standby
Press the STANDBY key to switch between standby and operation mode. Timer recordings will
record in this mode.
Deep Standby
Hold the STANDBY key pressed for 3 seconds to switch to the Deep Standby
mode. To switch again to operation mode, press the STANDBY key again. Timer
recordings will not record in this mode.
18