Karcher SDP 9500 - Manual (Page 15)

– 7
1 Power cord with plug
2 Level sensor
3 Level sensor stopper
4 Ventilation button
5 Carrying handle
6 Hose connection 1" (25.4 mm)
7 Cable connector
Please follow the safety instructions before
start-up!
Illustration
Î
For a 1“ (25.4 mm) hose, the hose con-
nection must first be sawed off
Note:
The larger the hose diameter and the short-
er the hose, the higher the feed rate.
Illustration
Î
Screw the hose connection on to the
pump
Î Push the hose on the hose connection
and fasten it with appropriate hose clip
Illustration
Î
Extend the folding feet (only SCP
9000).
Illustration
Î
In automatic operations mode, set the
required switching height by clamping
the level sensor cable in the stopper.
Illustration
Î
In manual operations mode, align the level
sensor upward (cable pointing downward).
Tip: Push the cable of the level sensor like a
loop through the handle.
Illustration
Î
Place the pump on a level, stabile sur-
face in the liquid to be transported, en-
sure that it is standing firmly or immerse
it using a rope tied to the handle.
The suction area should not be blocked
fully or partially through the impurities.
Illustration
Î
When installing the pump, you must
make sure that the pump can be sub-
merged up to the max. submersion
depth (h1) of 9 m, but only has a max.
flow height (h2) of 6 m (SCP 9500) or 7
m (SDP 9000).
The flow height indicates the height dif-
ference between the water level and
water exit at the end of the flow hose.
You have to adhere to the flow height
for the pump to flow. This must be ob-
served throughout the entire pump run,
as the flow height will increase with a
decreasing water level (due to the
pumping).
Operation
Description of the Appliance
Preparing the Appliance
15 EN