Advantech Vechicle Mounted Terminal PPC-V106 - Manual (Page 29)

17 Chapter 3
2. Place the HDD inside the HDD bracket and tighten four screws
(#1) from both sides of the HDD bracket.
3. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the HDD
bracket. Connect the HDD cable to the HDD. Make sure that the
red wire corresponds to Pin 1 on the connector, which is labelled on
the board. Plug the other end of the cable into the HDD, with Pin 1
on the cable corresponding to Pin 1 on the HDD.
3.3 Placing the Rubber Seal
To ensure that your PPC-V106 stays dry, the supplied rubber seal must be
placed correctly between the front bezel and back cover. Please note the
direction of the seal. The mark should be up.
Figure 3.1: Placing the Rubber Seal
HDD (Bottom up)
Pin 1
1
Marked
UP
Flat (UP)