Aurora Multimedia ICS-SP20 - Manual (Page 10)

ICS-SP20 User Manual
9
7.5 Audio Settings
Volume -- Selects the current (default) volume level
Spatial Effect -- Specifies the strength of 3D-spatial effect
7.6 Tuner Settings
Default Chan -- Specifies the default channel, which will be selected upon ICS-SP20 power-up.
If this default channel is set to “0” -- the default channel will be the last channel
selected before the ICS-SP20 was powered off.
Rename Current Channel
-- Change the text label assigned to the current channel. This label is shown (if
enabled) on screen, along with the channel number, when the ICS-SP20 is
switched to this channel. Display of labels and channel numbers can be globally
disabled on enabled, see the subsequent menu options.
Show Label -- Setting to enable will show up to an 8 character label specific to the channel
when changing channels.
Show Number -- Setting to enable will show up the channel number when changing channels.
Mode
-- Select tuner mode (channels allocation) to use, among broadcast and several
cable options.
Tune Channels -- Scans the channels, looking for valid signal presence, and “remembers” which
channels are valid and which are not. This “validity mask” is used then for
channel browsing using channel +/- buttons (so that a user browses through the
defined channels only). Note that before this operation ICS-SP20 must be
connected to RF-antenna or cable TV.