Aurora Multimedia ICS-SP20 User Manual
Page 13
ICS-SP20 User Manual
12
If the password is reset, the user is prompted to enter new password on his/her first access to V-Chip
limit. For all subsequent accesses the user will have to use the password that was specified during the first
access. In the event the password is forgotten the V-Chip settings can reset by holding the enter button
for 5 sec. When prompted for the password enter right, left, right, left, enter and it will be reset to default
values.
7.10 Troubleshooting
Symptom Checks
Key on remote is pressed but
nothing happens
See if the upper LED of ICS-SP20 is fast-blinking while
pressing key and aiming remote at IR sensor on the display.
If it is not -– check the batteries in the remote.
Image is Green
Make certain Option slot is select to YPbPr
No control of the display via
Menus
Under panel settings check to see if correct model is
selected.
No Image
Check to see if Option Slot is selected as source
Cannot switch to a particular TV
channel using channel +/-
browse keys.
The channel is selectable by browsing keys only if it is
marked as “valid”. To be marked as “valid” the channel must
have a good TV signal during the “channel scan” operation.
Repeat the channel scan (making sure aerial/cable
connection is good). Also the channel validity can be edited
manually.