Sony NAS-CZ1 - Manual (Page 25)

Tu
n
e
r
25 GB
Manual tuning preset
You can manually tune in and store the radio
frequency of the desired stations.
1
Press TUNER BAND repeatedly to
select “FM” or “AM”.
2
Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
3
Press TUNING + or – repeatedly to tune
in the desired station.
4
Press TUNER MEMORY.
5
Press TUNING + or – repeatedly to
select the desired preset number.
6
Press ENTER.
7
Repeat steps 1 through 6 to store other
stations.
Other operations
To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
FUNCTION on the system, press ?/1 on the
system. When you change the interval, all the
AM preset stations are erased. To reset the
interval, repeat the same procedure.
Tips
• The preset stations are retained for about half a day
even if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
To Do this
Tune in a station
with a weak signal Follow the procedure described
in “Manual tuning preset”
(page 25).
Set another station
to the existing
preset number After step 4, press TUNING +
or – repeatedly to select the
preset number you want to store
the station.