ATEN CS-88A User Manual

Page 14

Advertising
background image

4. Plug the power adapter cable into the Master View’s Power Jack, then plug

the adapter into an AC power source.

5. Repeat these steps for any other Third Stage units you wish to connect.

6. Plug in the power adapters for all the Second Stage Master View units.

7. Plug in the power adapter for the First Stage Master View unit.

8. Turn on the power to all the computers.

Note: The Power On sequence requires that all Third Stage units be powered

on first. After they are all on, the Second Stage units must be powered
on next. After all the Second Stage units are on, the First Stage unit must
be powered on. Only after all the Master Views have been powered on in
this sequence, can the computers be powered on.

2002-12-27

10

CS-88A User Manual

Advertising