Sony KDL-W40A11E - Manual (Page 35)

35 GB
Usi
ng t
he Menu
Audio Filter Improves the sound for individual channels in the case of distortion
in mono broadcasts. Sometimes a non-standard broadcast signal
can cause sound distortion or intermittent sound muting when
watching mono programmes.
1 Press M/m to select “Low” or “High”, then press OK.
If you do not experience any sound distortion, we recommend
that you leave this option set to the factory setting “Off”.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
Note
You cannot receive stereo or dual sound when “Low” or “High” is
selected.
Skip Skips unused analogue channels when you press PROG +/- to
select channels. (You can still select a skipped channel using the
number buttons.)
1 Press M/m to select “Yes”, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
To restore a skipped channel, select “No” in step 1.
Decoder Views and records the scrambled channel selected when using a
decoder connected to the scart connector
/ 2 either
directly or via a VCR.
Note
Depending on the country/region selected for “Country” (page 31), this
option may not be available.
1 Press M/m to select “On”, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
To cancel this function afterwards, select “Off” in step 1.
ATT Attenuates the RF signal. In case of a strong RF signal, some video
interference may be displayed.
1 Press M/m to select “On”, then press OK.
2 Press m to select “Confirm”, then press OK.
3 Press m to select “OK”, then press OK.
Note
When “ATT” is set to “On”, picture noise may occur during VCR
recording when turning on/off the TV or selecting a TV channel.
In this case, connect your aerial to the input socket on your VCR, then
connect the output socket on your VCR to the
socket on the rear of
the TV. Confirm that the VCR can record the digital channels.
Option Description
Continued