Sony KLV-15SR1 - Manual (Page 25)

25 Additional Information
Additional Information
Troubleshooting
If you have any problem while viewing your TV, please check the following
troubleshooting guide. If the problem persists, contact your Sony dealer.
Problem Possible remedies
No picture
No picture and no sound
No sound
Good picture but no sound
Poor picture/sound
Snowy picture and noisy sound
Distorted picture and noisy sound
Good picture but noisy sound
Dotted lines or stripes
Double images or “ghosts”
• Check the AC cable, aerial and the VCR
connections (pages 7 and 8).
• Press TV I/1 on the remote (page 12).
• Press I/1 on the TV to turn off the TV for about
five seconds, then turn it on again (page 12).
• Press 2 + to increase the volume level (page 13).
• Press % to cancel the muting (page 13).
• Check the aerial cable and connection on the TV,
VCR and on the wall (page 7).
• Check the aerial type (VHF/UHF). Contact a Sony
dealer for advice.
• Adjust the aerial direction. Contact a Sony dealer
for advice.
• Try using a booster, as signal transmission may be
low.
• Display the “SET-UP” menu and select
“MANUAL SET-UP” to preset the channel again
(page 22).
• Turn off or disconnect the booster if it is in use, as
broadcast signals may be too strong.
• If the sound of all the channels are noisy, display
the “SET-UP” menu and select “AUTO SET-UP”
to preset the channels again (page 21).
• If the sound of some channels is noisy, select the
channel, then display the “SET-UP” menu and
select the appropriate TV system (“SYSTEM”)
(page 22).
• Do not use a hair dryer or other interference
sources near the TV.
• Adjust the aerial direction for minimum
interference. Contact a Sony dealer for advice.
• Use a highly directional aerial.
• Adjust the aerial direction. Contact a Sony dealer
for advice.
• Turn off or disconnect the booster if it is in use, as
the booster may be inappropriate.
Additional Information
continued