Alpine CDM-7874 - Manual (Page 10)

8
-EN
Basic Operation
g DN
f UP
BAND
Setting Time
1
While the clock time is displayed, press and hold
the CLK (clock) button for at least 3 seconds.
The time indication will begin to blink.
2
Press the ZERO button while the time indication
is blinking to set seconds to "0".
3
Press the HOUR button to adjust the hours while
the time indication is blinking.
4
Press the MIN button to adjust the minutes while
the time indication is blinking.
The time indication will stop blinking 5 seconds
after the last adjustment. The time will
automatically be set.
Changing Audio Level Display
Pattern (CDM-7874 only)
1
Press the SETUP button for at least 3 seconds.
2
Press g DN or f UP button to select the
DISP mode.
Audio Level indicator
Volume indicator
Example settings:
Bass center frequency: 100 Hz
Bass band width: WIDE1
Bass level: - 6
→ DISP1 → DISP2 → DISP OFF
3
Press BAND button to switch the display pattern.
DISP1:
Lights the Volume indicator and Audio Level
indicator.
DISP2:
Lights the mode and value bars to show the
settings in the Bass engine display.
NOTE
The last mode set will remain in effect. The mode and
value bars light and show the Bass engine settings.
DISP OFF:
Turns off the light in Bass engine display.
If you set DISP OFF, the Volume indicator, Audio
Level indicator, and Bass engine displays are
not lit at all times.
4
Press the SETUP button to return to normal
mode.
ZERO HOUR MIN CLK SETUP