Alpine CDM-7874 - Manual (Page 12)

10
-EN
Manual Storing of Station Presets
1
Select the radio band and tune in a desired radio
station you wish to store in the preset memory.
2
Press and hold the Preset buttons (1 through
6) that you want to store the station on for at
least 2 seconds.
The selected station is stored. The display shows
the band, preset No. with a triangle (
9) and
station frequency memorized.
3
Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply
select the band desired and repeat the
procedure.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
AM and D.A.P.).
NOTE
If you store a station in a preset memory which already
has a station, the current station will be cleared and
replaced with the new station.
Automatic Memory of Station
Presets
1
Press the SOURCE button to select the radio
mode.
2
Press the BAND button repeatedly until the
desired radio band is displayed.
3
Press and hold the A. ME button for at least 2
seconds.
The frequency on the display continues to
change while the automatic memory is in
progress. The tuner will automatically seek and
store 6 strong stations in the selected band. They
will be stored into presets 1 to 6 buttons in order
of signal strength.
When the automatic memory has been
completed, the tuner goes to the station stored in
the preset location No. 1.
NOTE
If no stations are stored, the tuner will return to the
original station you were listening to before the auto
memory procedure began.
Radio Operation
SOURCE A.ME BAND/D.A.P.
Preset button (1 through 6)