Sony KDL-46V25L1 - Manual (Page 7)

7
(GB)
SU-WL51
2-652-380-11(1)
2
Adjust the angle of the arms.
When installing the TV or monitor perpendicularly (0
degrees), adjustment of the arm angle (procedures 1
and 2 below) is not necessary. Make sure that each
arm base is screwed in securely.
1
Remove the screws from the top and bottom centre
of the both arm bases. Then choose the notch
corresponding to the desired angle (5, 10, 15 or 20
degrees) and fit each arm base to them.
If you are installing the KLV-40U100M, do not
choose the notch for 20 degrees.
2 Firmly secure each arm base using the screws
removed in the above procedure 1.
Notes
• Be sure to adjust the angles of the right and left arms to the
same angle.
• Be careful not to pinch your fingers when adjusting the
angle of the arms.
• When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 Kgf·cm}.
• Make sure that the two arm bases are screwed in securely.
Notes on the adjustment angles
• When installing TV or monitor models other than
those specified on page 2 (depending on the
model's size and dimensions, etc.), the adjustment
angles listed (0, 5, 10, 15, 20 degrees) for the arms
may be limited.
• For the available adjustment angles of the arms
when installing TV or monitor models other than
those specified on page 2, refer to the operating
instructions or the leaflet (“Installing the Wall-
Mount Bracket”) supplied with the TV or monitor.
2 1
• 0 degrees: Leave the white screws tightened as they are.
• Other than 0 degrees: Remove the white screws.
Arm base
3
Change the position of the
Mounting Hook Unit support
shafts.
1 Remove the screws securing the both left and right
Mounting Hook Unit support shafts, and then move
the Mounting Hook Unit support shafts to the inner
position. Make sure the marks on the both
Mounting Hook Unit support shafts align with the
F marks on the plate unit.
2 Secure the Mounting Hook Unit support shafts
using the screws from procedure 1.
Notes
• When using an electric screwdriver, set the torque
setting to approximately 2 N·m {20 Kgf·cm}.
• Make sure that the two Mounting Hook Unit support
shafts are screwed in securely.
Mounting Hook Unit
support shaft
01GB01COV.book Page 7 Tuesday, December 20, 2005 4:59 PM