Sony NEX-VG20 - Manual (Page 113)

11
Table of C
on
ten
ts
Sear
ch image
Inde
x
US
Wireless Remote Commander
 DATA CODE button (83)
Displays the date and time or camera setting
data of the recorded images when you press
this button during playback.
 PHOTO button (32)
The on-screen image when you press this
button will be recorded as a still image.
Note
[Single Shooting] is always set regardless
[ Drive Mode] setting when using the
PHOTO button on the Wireless Remote
Commander for shooting. Note that shooting
may not be possible if it is difficult to focus on
a subject.
 SCAN/SLOW buttons (36)

 /  (Previous/Next) buttons (36)
 PLAY button
 STOP button
 DISPLAY button (25)
 Transmitter
 START/STOP button (31)
 Power zoom buttons
You cannot use this button with this
camcorder.
 PAUSE button


 VISUAL INDEX button (34)
Displays an Event Index screen during
playback.

 /  /  /  /ENTER buttons
When you press any of these buttons, the
orange frame appears on the LCD screen.
Select a desired button or an item with
 /  /  /  , then press ENTER to enter.
Notes
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 112).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the light blue frame disappears. When
you press any of  /  /  /  , or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen using  /  /  /  .





Insulation sheet