Sony FWD-50PX3 - Manual (Page 50)

4 GB
Precautions
On safety
• A nameplate indicating operating voltage, power
consumption, etc. is located on the rear of the unit.
• Should any solid object or liquid fall into the cabinet,
unplug the unit and have it checked by qualified personnel
before operating it any further.
• Unplug the unit from the wall outlet if it is not to be used
for several days or more.
• To disconnect the AC power cord, pull it out by grasping
the plug. Never pull the cord itself.
• When you install the unit on the floor, be sure to use the
optional stand.
On installation
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs, blankets,
etc.) or near materials (curtains, draperies) that may block
the ventilation holes.
• Do not install the unit in a location near heat sources such
as radiators or air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration or shock.
• When you install multiple equipment with the unit, the
following problems, such as malfunction of the remote
control, noisy picture, noisy sound, may occur depending
on the position of the unit and other equipment.
On the PDP (Plasma Display Panel)
• You may see some bright spots of red, blue or green
remain, or dark spots appear on the screen. These do not
indicate malfunction. Although the plasma display panel
is manufactured with extremely high precision
technology, it can generate a few dark or bright pixels.
Dark spots on the edge of the screen, or striped color and
brightness irregularities do not indicate malfunction.
• Because of the way it is made, when this plasma display
panel is used in places with low air pressure, such as at
high altitudes, a buzzing or humming noise may emanate
from the unit.
• If you continue to display the same image on the screen for
a long period of time, part of that image may burn into the
screen and leave a ghosting image behind. To avoid this,
please use the screen saver function provided to equalize
use over the entire screen. If ghosting occurs, use the
screen saver function, or use some kind of video or
imaging software to provide constant movement on the
screen. If light ghosting (image burn-in) occurs,it may
become less conspicuous, but once burn-in occurs, it will
never completely disappear.
• To protect the plasma display, this unit will not accept
commands from the remote control or from the function
buttons on the unit for a certain period of time after the
unit has been switched ON/STANDBY. After one of these
operations, wait about 8 seconds before entering a
command.
On cleaning
• Be sure to unplug the power cord before cleaning the
display.
• Gently wipe off stains using a dry, soft cloth. Wipe off
grimy stains using a cloth slightly moistened with a mild
detergent, then wipe the area again using a dry, soft cloth.
• Never use rubbing alcohol, benzine, thinner or insecticide
for cleaning. They may damage the finish of the cabinet or
can remove the markings on it.
Notes on handling and cleaning the display
panel
The display panel’s special surface finish should be treated
with care when cleaning or handling the display.
When cleaning it, use a soft cleaning cloth to avoid touching
the panel directly.
On repacking
Do not throw away the carton and packing materials.
They make an ideal container in which to transport the unit.
When shipping the unit, repack it as illustrated on the carton.
If you have any questions on this unit, contact your
authorized Sony dealers.
Introduction