Sony FWD-50PX3 - Manual (Page 77)

31 GB
GB
Screen Saver Settings
If an image that does not change in brightness or a still
image, such as the kind of image displayed on a PC, is
displayed for a long time, an after-image (ghosting)
may be burned into the display panel. To correct or
lessen the severity of this problem, this unit is
equipped with a screen saver function. “Screen Saver”
includes the following menus.
All White Turns the entire screen white to equalize the irregularities caused by burn-in.
“On”: Select to reduce image retention and burn-in by turning the screen all white
for about 30 minutes.
“Off”: Select to cancel “All White”.
Pic. Inversion “On”: Inverts the image hue.
“Auto”: Carries out the “Pic. Inversion” process once a day.
Select the desired time to set “Start Time” and “End Time” with
F/f, and then press
.
“Off”: Sets the “Pic. Inversion” to “Off”.
If you set “Start Time” and “End Time” to the same time, the setting of “Start Time” takes
priority over that of “End Time”. The display image does not return to the original image at the
“End Time”. If “Pic. Inversion” is activated when the color tone of the image has already been
reversed, the reversing is terminated.
Background Changes the brightness of background of a picture (aspect ratio 4:3). “Gray”, “Dark
Gray”, or “Black” can be selected.
The lower the brightness contrast between the picture and its background, the more
reduction in after image and burn-in may result.
Auto Dimmer When “On” is selected, you can reduce the chance of image retention and burn-in by
gradually reducing the brightness when there has been no or very little movement in
the image for more than 5 minutes. The brightness is automatically restored when
movement is detected.
Pic. Orbit “Orbit”: Select “On” to reduce the chance of image retention and burn-in by
automatically moving the image position after a certain time frame.
“Orbit Range”: When moving the image position, you can select the range to move
from “Small”, “Mid” or “Large”.
“Orbit Cycle”: Select the desired time frame for changing the image position from
“16 sec”, “32 sec”, “64 sec” and “320 sec”.
Displays the new image position of the inversed picture after a certain time frame during
picture inversion.
Note
Note
Note