Sony FWD-50PX3 - Manual (Page 53)

7 GB
GB
Front Panel
Location and Function of Parts and Controls
1 INPUT button
Press to select a signal to be input from the INPUT or
OPTION connector.
The signal to be input switches as follows each time
you press the INPUT button.
When an optional adaptor supporting the video signal
is not installed in the OPTION slot, OPTION will be
skipped.
2 MENU (page 19)
34 f/F (volume/cursor) button
Press to control speaker volume. When the menu is
displayed, press to move the cursor (yellow) or set a
value.
5 ENTER button
Press to set your choice.
6 1
Switches the display on or off (standby).
To protect the panel, a certain amount of time is
required to turn the display to on/off (standby). When
you turn the display on again, soon after turning it off,
wait about 8 seconds before you turn it on again.
7 Remote control sensor
8 POWER/STANDBY indicator
• Lights up in green when the display is switched on.
• Lights up in red when the display is in standby
mode. Lights up in orange when the display enters
the power saving mode while a signal is input from
a PC.
When the POWER/STANDBY indicator blinks, see
page 37.
When the “LED” option in the “Multi Display”
settings is set to “Off” and the “Position” option is not
set to the right-bottom, the indicator does not light up
in green even when the display is turned on, except for
the case of no signal or an unsupported signal.
Note
Note