Sony MZ-R37 - Manual (Page 7)

7
Record an MD.
3
1 Press and slide REC upward.
“REC” lights up and recording starts.
2 Play the CD or tape you want to
record.
To stop recording, press p.
“EDIT” flashes while data of the recording
(the track’s start and end points, etc.) is
being recorded. Do not move or jog the
recorder or disconnect the power source
while the indication is flashing in the
display.
CD player,
cassette recorder,
etc. (source)
To
Pause
Record from the end of the
previous recording
Record partway through the
previous recording
Remove the MD
1) A track mark is added at the point where you press P; thus the remainder of the track will be
counted as a new track.
2) Once you open the lid, the point to start recording will change to the beginning of the first track.
Check the point to start recording on the display.
If the recording does not start
•Make sure the recorder is not locked (page
17).
•Make sure the MD is not record-protected
(page 26).
•Premastered MDs cannot be recorded over.
Note
If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected)
when the recorder is operating, the lid will
not open until the power is restored.
p•CHARGE
Press
P 1)
Press P again to resume recording.
END SEARCH and slide REC upward.
(, + or = to find the start point
of recording and press
p to stop. Then
slide REC upward.
p and slide OPEN to open the lid. 2)
z
•The level of the recorded sound is adjusted
automatically.
•You can monitor the sound during
recording. Connect the supplied
headphones with remote control to
PHONES/REMOTE and adjust the volume
by pressing VOL +/–. This does not affect
the recording level.
REC