Aastra Telecom VentureIP - Manual (Page 8)

5 Model VentureIP 480i User Guide
Installation
Shared Network Connection
To connect a network device (such as a computer) to the phone, connect
an Ethernet Cable into the network port on the back of the phone marked
with
` . Plug the other end of the Ethernet Cable into the network jack
on the network device that you are sharing the network connection with.
Note: The ` jack on the 480IP does not supply inline power onto
other network devices.
Note: All Ethernet cables must be category 5/5e straight-through cables, such as the
cable provided with your phone.
Installing on a Desk
1. Route the cables through the opening in the stand.
2. Attach the stand by inserting the tabs on the stand (marked with o ) into
the slots on the bottom of the phone. For a higher viewing angle, use the
slots marked
n . For a lower viewing angle, use the slots marked m .
3. Push the stand towards the phone until it snaps into place.
4. Press the cords into the grooves provided on the bottom of the stand.
This will allow the stand to sit flat on a desk surface.