Sony CMT-M90DVD - Manual (Page 39)

39 GB
Tape
Timer recording radio
programs
To timer record, you must first preset the radio
station (see “Presetting radio stations” on page
33) and set the clock (see “Setting the clock”
on page 11).
1
Tune in the preset radio station (see
“Listening to the radio” on page 34).
2
Press CLOCK/TIMER SET on the
remote.
3
Press + or – on the remote repeatedly
to select “REC SET?”, then press
ENTER/YES on the remote.
“ON” appears and the hour indication
flashes.
4
Set the time to start recording.
Press + or – on the remote repeatedly to set
the hour, then press ENTER/YES on the
remote.
The minute indication flashes.
Press + or – on the remote repeatedly to set
the minute, then press ENTER/YES on the
remote.
5
Set the time to stop recording following
the same procedure as step 4.
6
Load a recordable tape.
7
Press ?/1 to turn off the system.
Other operations
To
Check the settings/
activate the timer
Change the setting
Cancel the timer
Notes
• You cannot activate the Daily Timer and recording
timer at the same time.
• If you use the recording timer and the Sleep Timer
at the same time, the Sleep Timer has priority.
• Do not operate the system from the time the system
turns on until the recording starts (about 15 seconds
before the preset time).
• If the system is on about 15 seconds before the
preset time, the timer-recording will not be
activated.
• The volume is reduced to minimum during
recording.
Do this
1 Press CLOCK/TIMER
SELECT on the remote.
2 Press + or – on the remote
repeatedly until “REC
SELECT?” appears, then press
ENTER/YES on the remote.
Start over from step 1.
1 Press CLOCK/TIMER
SELECT on the remote.
2 Press + or – on the remote
repeatedly until “TIMER
OFF?” appears, then press
ENTER/YES on the remote.