Sony DCR-TRV33 - Manual (Page 100)

100
Monitoring the new recorded sound
The POWER switch should be set to .
Operate by touching the panel.
(1) Play back the tape on which you added audio.
(2) Press FN to display PAGE1.
(3) Press MENU to display the menu.
(4) Select AUDIO MIX in
, then press EXEC (p. 178).
(5) Press r/R to adjust the balance between the original sound (ST1) and the new
sound (ST2), then press EXEC.
About 5 minutes after you disconnect the power source or remove the battery
pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The
default setting is original sound only.
Audio dubbing
VCR SET
H i F i SOUND
AUD I O M I X
A/V
c DV OUT ST1 ST2
EXIT
RET. EXEC R r