Sony DCR-TRV460 - Manual (Page 110)

Troubleshooting 110
Warning indicators
and messages
Self-diagnosis display/Warning indicators
If indicators appear on the screen or in the viewfinder, check the following. See the page in parentheses
for details.
Indication Cause and/or Corrective Actions
C:ss:ss/E:ss:ss (Self-
diagnosis display) Some symptoms can be fixed by yourself. If the problem persists even after
you tried a couple of times, contact your Sony dealer or local authorized
Sony service facility.
C:04:ss
cA battery pack that is not an “InfoLITHIUM” battery pack is being used.
Use an “InfoLITHIUM” battery pack. (p. 118)
C:21:ss
cMoisture condensation has occurred. Remove the cassette and leave your
camcorder for at least 1 hour, then re-insert the cassette. (p. 121)
C:22:ss
cClean the head using a cleaning cassette (optional). (p. 121)
C:31:ss / C:32:ss
cSymptoms that are not described above have occurred. Remove and
insert the cassette, then operate your camcorder again. Do not perform
this procedure if moisture starts to condense. (p. 121)
cRemove the power source. Reconnect it again and operate your
camcorder again.
cChange the tape.
cPress the RESET button and operate your camcorder again (p. 126).
E:61:ss / E:62:ss
cContact your Sony dealer or local authorized Sony service facility.
Inform them of the 5-digit code, which starts from “E.”
101-0001 (Warning indicator
pertaining to files) • The file is damaged.
• The file is unreadable.
• You are trying to carry out the MEMORY MIX function on a movie
(p. 43).
E (Battery level warning) • The battery pack is nearly used up.
• Depending on the operating, environmental, or battery conditions, the
E indicator may flash, even if there are approximately 5 to 10 minutes
remaining.
% (Moisture condensation warning)* cEject the cassette, set the POWER switch to (CHG) OFF, and leave it for
about 1 hour with the cassette lid open (p. 121).
(Warning indicator pertaining to
the “Memory Stick”)
• No “Memory Stick” is inserted.