Sony DCR-TRV460 - Manual (Page 27)

D:\##SAGYO\DTP-shanhai-agari\824719S DCRTRV360-US\824719S DCR-TRV360_US\824719S DCR-
TRV360_US\3087921111 DCR-TRV360\01GB04REC.fm
master:Right
Rec
o
rdin
g
DCR-TRV360/TRV361/TRV460
3-087-921-11(1)
Recording 27
Move the power zoom lever slightly for a
slower zoom. Move it further for a faster
zoom.
To record wider range of view
Move the power zoom lever towards W.
The subject appears farther away (Wide
angle).
To record closer view
Move the power zoom lever towards T.
The subject appears closer (Telephoto).
Using the built-in light
You can use the built-in light to suit your
shooting situation. The recommended
distance between the subject and camcorder
is about 1.5 m (5 feet).
Press LIGHT repeatedly to select a setting.
The settings are displayed cyclically in the
following order.
No indicator displayed: Always records
without using the built-in light.
m
: Automatically turns on and off
according to the ambient brightness.
m
: Always turns on.
To turn off the built-in light
Press LIGHT repeatedly until no indicator
appears on the screen.
b Notes
• The built-in video light emits very bright light,
which is perfectly safe in normal use. However,
avoid directly aiming the light at a subject’s eyes
from very close range.
• The battery pack discharges quickly while the built-
in light is turned on.
• When you do not use your camcorder, turn the built-
in light off and remove the battery pack to avoid
turning on the built-in light accidentally.
• When flickering occurs while shooting in the
mode, press LIGHT until
appears.
• The built-in light may turn on/off when you use the
[PROGRAM AE] or backlight function while
shooting in the
mode.
• The built-in light is turned off in the following cases:
– While the END SEARCH function is working.
– Interval time of Interval recording.
– When you leave it on for more than 5 minutes with
the POWER switch set to CAMERA-MEMORY.
– When it stays on in the mode for more
than 5 minutes.
– When you leave it on for more than 5 minutes with
no cassette inserted or after the tape has run out.
• When you use the conversion lens (optional), light
from the built-in light is blocked and may not
illuminate the subject properly.
LIGHT
Built-in light
, continued