Sony DCR-DVD205 - Manual (Page 22)

22
5
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack on your camcorder.
• Disconnect the AC Adaptor holding both
your camcorder and the DC plug.
To remove the battery pack
Slide the POWER switch to OFF (CHG).
Slide the BATT (battery) release lever and
remove the battery pack.
• When you remove the battery pack, make sure
that none of the respective lamps of the POWER
switch (p.25) is on.
When storing the battery pack
Use up the battery pack completely if you do
not intend to use it for a long time (p.137).
To use an outside power source
Make the same connections as you do when
charging the battery pack. The battery pack
will not lose its charge in this case.
Charging time (full charge)
Approximate time (min.) required when you
fully charge a fully discharged battery pack.
Recording time
Approximate time (min.) available when you
use a fully charged battery pack.
For DCR-DVD105/DVD605
For DCR-DVD205/DVD705
Battery pack Charging time
NP-FP50 (supplied) 125
NP-FP70 155
NP-FP71 170
NP-FP90 220
BATT (battery)
release lever
Battery pack
Continuous
recording
time Typical
recording
time*
NP-FP50
(supplied) 100
115 0 45
0 50
NP-FP70
215
240 0 95
110
NP-FP71
255
290 115
130
NP-FP90
385
435 175
195
Battery pack
Continuous
recording
time Typical
recording
time*
NP-FP50
(supplied)
0 80
0 85
0 90
0 40
0 40
0 45
NP-FP70
170
185
190 0 85
0 90
0 95
NP-FP71
200
220
230 100
110
115
NP-FP90
300
335
345 150
165
170
Step 2: Charging the battery pack (continued)