Sony DVP-CX850D - Manual (Page 67)

67
Settings and Adjustments
Adjusting the speaker volume
1 While you stop playback, select “SPEAKER SETUP”
after pressing SET UP.
2
Select “TEST TONE” and set “TEST TONE” to “ON.”
You will hear the test tone from each speaker in
sequence.
3
From your listening position, select “BALANCE” or
“LEVEL” and adjust the value of “BALANCE” and
“LEVEL” using >/..
During this adjustment, the test tone is emitted from
both speakers simultaneously.
4 Select “TEST TONE” and set “TEST TONE” to “OFF”
to turn off the test tone.
Controlling the TV or the
AV Receiver (Amplifier)
with the Supplied Remote
Z
If you adjust the remote signal, you can control your TV
with the supplied remote. Default setting is to control
Sony TVs with the g mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote.
Controlling TVs with the remote
1 Slide the TV/DISC EXPLORER/DVD switch to TV.
2
Hold down 1/u (POWER), and enter your TV’s
manufacturer’s code (see the table on the next
page) using the number buttons. Then release
1/u
(POWER).
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number may reset to 01 (Sony). Reset the appropriate code
number.
Number buttons
TV/DISC EXPLORER/
DVD switch
1/u (POWER)
1 2 3
4 5 6
7 8 9
0
A B C D ALL
DVD CD