Sony HT-DDW900 - Manual (Page 29)

29 US
E:\SEM_soowan(film)\J9050000_2662263112DDW900_US\2662263112\US03CON_HT-
DDW900-U.fm masterpage: Right
HT-DDW900
2-662-263-11 (2)
Gettin
g
Sta
rted
Insert two R6 (size-AA) batteries in the
RM-AAP013 remote commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix alkaline batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
Tip
Under normal conditions, the batteries should last
for about 3 months. When the remote no longer
operates the receiver, replace all the batteries with
new ones.
6: Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
Press SPEAKERS (OFF/A/B/A+B)
repeatedly to select the front
speaker system you want to drive.
To turn off the speaker output, press
SPEAKERS (OFF/A/B/A+B) repeatedly until
the “SP A” and “SP B” indicators on the
display do not light up.
Inserting batteries into the
remote
To select Light up
The speakers connected to the
SPEAKERS FRONT A terminals SP A
The speakers connected to the
SPEAKERS FRONT B terminals SP B
The speakers connected to both the
SPEAKERS FRONT A and B
terminals (parallel connection) SP A and
SP B
?/1
AUTO CAL MIC
SPEAKERS (OFF/A/B/A+B)
PHONES VIDEO 3 IN/PORTABLE AV IN
VIDEO L AUDIO R
MEMORY/ ENTER TUNING MODE TUNING 2CH A.F.D. MOVIE MUSIC MULTI CH IN MUTING
DISPLAY INPUT MODE
INPUT SELECTOR
MASTER VOLUME
SPEAKERS
(OFF/A/B/A+B)
US01COV_HT-DDW900-U.book Page 29 Thursday, December 15, 2005 4:08 PM